Open the housing: by removing the front cover. To do so, remove the cover screw located at the bottom of the unit
Remove the PCB: by turning counter-clockwise and removing the "Easy Lock". Note: Do not touch the face of the PYRO sensor
Knock out: the required mounting and wiring holes.
Thread the wires: through the wiring holes (from the outside of the unit) using the appropriate wiring hole knock outs. Note: Electronics Line 3000 recommends using 20~22
AWG connection cable
Seal the wiring hole: with the foam plug provided.
Choose an appropriate mounting height: from table and attach the base to the wall.
Connect the wires: to the terminal block.
Sensor: Low noise, high sensitivity, dual element, PIR sensor
Pulse Count (Sensitivity): Two levels auto pulse signal processing, 1~3 pulses or 2~6 pulse selectable
Temperature Compensation: Auto
Startup Time: 60 seconds after power up
Detection Speed: 0.2~7mc
Lens: Second generation fresnel pet immunity lens
White Light Immunity: Yes
Coverage: 12m x 1100
Installation Height: 1.1~3.1m adjustable
Alarm Indication: Green LED constant light 3 seconds(can be disabled)
Alarm Output: N.C., rating 28VDC 0.15A
Anti-Tamper Switch: N.C., opens when cover removed, rating 0.15A, 28Vdc
Power Input: 9~16VDC, 18mA
Operating Temperature: -10C~50C
Operating Humidity: 95%
Size: 94 x 66 x 52mm / 3.7 x 2.6 x 2.0in (L x W x H)